The assembly drag chain is composed of many subtitles, and the middle of the chain link is easy to operate. It has the characteristics of high bearing capacity, large empty frame length, etc., and is suitable for various large, medium and small industrial equipment.

In many cases, during the specific application, the length of the assembly drag chain will exceed the capacity of the assembly drag chain. At this time, certain effective measures must be taken to ensure the operation without problems.

1. In the middle of the assembly drag chain, refit the ground skid plate to let the mobile phone end slide on the fixed end to deal with the problem of long-distance operation, so as to ensure the service life and practical application effect.

2. Refit the support point wheel to support the long-distance operation of the assembly drag chain at the support point, and reduce the weight to solve the problem of long-distance operation. The installation of the support point wheel must be scientific and standardized, which can more reasonably assist the assembly drag chain to operate at a long distance.

3. The guide slot is modified to run according to the predetermined motion track under the effect of the guide slot.

For long-distance operation, effective solutions shall be adopted according to the specific conditions of the construction site.

Nylon drag chain manufacturer Little knowledge

The assembly drag chain is a kind of overweight steel drag chain. The inner height, outer height and pitch diameter of the same specification and model are the same. The module chain link is composed of upper and lower drive chains and left and right support plates, and each link can be opened.

The support plate is divided into integrated type I, left and right separated type II and framework type III.

1. II The overall width of the support plate is generally 50mm to 1800mm, and the middle spacing of the diameter is 5mm. The height width ratio of the drive chain is determined by the larger straight diameter of the embedded conduit.

The assembly drag chain can be thickened according to the specific endless assembly.