The machine tool drag chain is used to maintain the common cables, oil pipes and bronchi of the machine tool, Nylon drag chain manufacturer The machine tool drag chain is divided into steel aluminum drag chain and engineering project plastic drag chain according to the material. According to the structural characteristics, it can be divided into bridge type plastic drag chain (cable can be seen outside) and fully enclosed plastic drag chain (cable can not be seen outside); According to the model and specification, it can be divided into small and medium-sized drag chains, general drag chains and large and medium-sized drag chains; According to the noise index, it can be divided into general drag chain and silent mode drag chain; According to the type, it can be divided into general drag chain, tandem drag chain and S-type drag chain.

During the long-distance operation of plastic drag chain, scientific and reasonable long-distance operation solutions must be established according to the specific conditions of the construction site to prevent and deal with the problems that plastic drag chain is prone to occur during long-distance operation, thus reducing the company's excess consumption and further improving productivity.

So how to correctly install the machine tool drag chain?

1. Inner height: the thickest one of the embedded cables, oil pipes, bronchi, water pipes, etc. shall be selected as the reference height, plus at least 10% of the height of the indoor space as the inner height of the drag chain. If it is overlapped, the specific height after overlapping shall be used as the reference height.

2. Inner width: select some thicker cables, oil pipes, bronchi, water pipes, etc. The sum of their diameters is used as the reference for the inner width of the drag chain, and at least 10% of the total width of the indoor space is reserved.

3. Application of spacers: transmission lines with large diameter differences should be separately paved, with the net weight evenly distributed, and can be separated with spacers when necessary. During fast or high-frequency operation, the transmission lines shall be separated from each other in capacity as far as possible without being juxtaposed with each other. It is proposed to use spacers when there are many cables, bronchi, oil pipelines, etc.